Milwaukee 48-22-8510 Manuel De L'utilisateur page 3

WARNING
Improperly connecting the
grounding wire can result in the risk of elec-
tric shock. Check with a qualifi ed electrician
if you are in doubt as to whether the outlet
is properly grounded. Do not modify the
plug provided with the chest/cabinet. Never
remove the grounding prong from the plug.
Do not use the chest/cabinet if the cord or
plug is damaged. If damaged, have it repaired
before use. If the plug will not fi t the outlet,
have a proper outlet installed by a qualifi ed
electrician.
CAUTION
Be sure to follow the assembly instructions for the appropriate chest/cabinet.
Do not use power tools to assemble chest/cabinet. Tighten bolts with hand wrenches.
Tools Required
Phillips
screwdriver
Hardware Included
NOTE: Items not shown to actual size.
Hardware Item
AA
BB
CC
DD
EE
GROUNDING
Chests/Cabinets with Three Prong Plugs
Chests/cabinets marked "Grounding Required"
have a power strip with a three wire cord and three
prong grounding plug. The plug must be connected
to a properly grounded outlet (See Figure A). If the
power strip should electrically malfunction or break
down, grounding provides a low resistance path to
carry electricity away from the user, reducing the
risk of electric shock.
The grounding prong in the plug is connected
through the green wire inside the cord to the
grounding system in the power strip. The green
wire in the cord must be the only wire connected
to the power strip's grounding system and must
never be attached to an electrically "live" terminal.
Your power strip must be plugged into an
appropriate outlet, properly installed and
grounded in accordance with all
codes and ordinances. The plug
and outlet should look like those in
Figure A.
ASSEMBLY
Safety 10 mm
goggles Wrench
Description
Bolt M6 x 15L
Washer M8
Bolt M8 x 20L
Screw M4 x 8L
Screw M6 x 12L
4
Item
Fig. A
NOTE: Begin product assembly close to the fi nal
intended location of your chest/cabinet. This prod-
uct is heavy and may be diffi cult to move after
assembly.
Attaching the Side Handle
Attach the side handle to the rolling cabinet using
13 mm
four bolts (AA).
Wrench
NOTE: The holes in the cabinet are tapped and do
not require nuts.
Quantity
4
16
16
20
8
Description
Side handle
Swivel caster with brake
Rigid caster
Bracket
Bumper
Cord Storage Brackets
Installing the Casters
CAUTION
Two people may be required
to complete installation.
CAUTION
Do not overtighten the screws.
1. Ensure all cabinet drawers are securely locked
into place using the key lock on the rolling cabi-
net.
2. Lay the rolling cabinet on its back. Use the pack-
aging material to protect the fi nish.
3. Mount the two swivel casters with brake to the
rolling cabinet using four bolts (CC) and washers
(BB) per caster. The swivel casters with brake
should be installed on the end of the cabinet with
the side handle.
4. Mount the two rigid casters to the opposite end
of the rolling cabinet using four bolts (CC) and
washers (BB) per caster.
5. Tighten all bolts securely with a wrench.
AA
6. Return the rolling cabinet to its upright position.
BB
CC
5
Quantity
1
2
2
2
4
4