TFK JOGGSTER trail Notice D'utilisation page 10

Close the belt buckle by audibly engaging both plugs (15)
• (Fig. IX)
in the belt buckle (16). If you want to open the harness, simply press
the button in the centre of the buckle (16). The harnesses can be
adjusted to the size of your child using the tensioning system x, y and
z. The harness is located at the 5 points x, y, z.
• (Fig. X) Insert the belly bar from above into the frame tubes. Secure
it by moving the clamping lever (17). By pressing the red buttons (18)
at the left and right side you can swivel it to different positions.
• (Fig. XI) You can set the height of the push bar by pressing the two
adjustment joints (23).
• (Fig. XII) The handbrake is a walking and parking brake at the
same time. To activate the parking brake, you must pull the brake
lever (20) fully tight and completely close the red parking lever (21),
so that the brake lever (20) remains tightened to the maximum and
the brake is permanently blocked. If the braking effect starts to
weaken, you can carry out a fine adjustment. To do so, turn the
adjusting screw (22) on the brake grip anti-clockwise and check the
braking effect again.
• (Fig. XIII) To close the Joggster Trail, you must push both locks (23)
upwards. They remain automatically open. Then you can move the
push bar (24) in forward direction. The frame construction
automatically closes.
• (Fig. XIV) Close the transport lock (25) on the frame to ensure that
the Joggster Trail does not accidentally open up again.
• (Fig. XV) If you are using the Joggster TRAIL in cross-country terrain,
please fasten the enclosed retention strap on the rear axle. Then pull
the side with the elastic band over your wrist.