O2Feel Bikes Urbain Manuel D'utilisation page 53

important if your bike is left outside regularly
and exposed to bad weather.
Paintwork
Paintwork needs regularly maintenance,
which will also preserve the look of your
bike.
Make sure that painted surfaces are in
flawless condition on a regular basis, and
correct any faults immediately.
Your approved O2Feel reseller will be happy
to o er advice about looking after surfaces.
Assemblies
All the bike assemblies, such as the headset,
the hub, the pedals and the bottom bracket,
experience natural wear. This depends
on the intensity and duration of use and
maintenance.
Check these parts regularly.
Clean and lubricate these parts regularly.
Bearings for full suspension frame and
sprung forks or other elements of the
suspension system
The components of the bike's suspension
system, bearings and elements of the
suspension system, are subject to much
more pressure than other bearings. This is
why they experience a lot of wear.
Check these parts regularly and thoroughly.
Follow the manufacturers' instructions.
Your approved O2Feel reseller will be
happy to o er advice about looking after
and, if necessary, replacing these sensitive
components.
You should also check the websites of the
relevant component manufacturers to find
out the most important points about looking
after parts that are subject to wear.
Regular inspections
The spokes will align themselves over the
first few miles that you cycle, the brake and
transmission cables will stretch and the
bearings will be broken in. This is why an
initial inspection should be carried out by
your approved O2Feel reseller after around
200 kilometres or four to six weeks. This
inspection is also important when it comes
to your rights under the guarantee.
You can watch our adjustment and
maintenance tutorials on our YouTube
channel.
53