Possible Malfunctions And Their Elimination - Agu PMBF2 Mode D'emploi

2. Clean the device with a slightly damp cloth. DO NOT SUBMERGE the
main block of the device in water or other liquids and DO NOT USE
chemical or abrasive cleaning agents.
3. Clean all plastic details of the unit immediately after they contact oily
substances, spices, vinegar and strongly flavored or coloring products.
Avoid contact with acids and citrus juices.
4. Always set the unit on a hard even surface before use.
5. Do not knock on the device, avoid hitting it and dropping it from height.
6. The device is designed for domestic use and should not be used for
commercial purposes.
7. Keep the device in a cool dry place.
POSSIBLE MALFUNCTIONS
12
AND THEIR ELIMINATION
If any problem arise during the operation of the device, first of all turn to the list
of possible failures.
Problem Possible
malfunctions
The formula is too Incorrect
temperature
cold/hot
settings
The device is not Wireless
connection and
shown among the
Internet are not
available ones
enabled
The display There is no water
in the system of
shows «Err»
the machine and
in the water tank
The machine The machine is not
connected to an
does not turn on.
alternating current
network
62
Solution
Check the temperature settings
Check if the wireless communication
function in your phone is turned on
Check if there is water in the water tank
Check if the machine is plugged into power
outlet
The «Warm water» There is no water
in the system or
button is flashing,
the water is too hot
and the machine
does not respond to
any buttons pressed
The display The device
does not light up is not turned on
The control panel
cable is damaged
or disconnected
Leakage of water The funnel is not
on the surface of the installed correctly
funnel
During the baby The container for
formula preparationis the mixture is not
only water poured (the installed correctly
machine «prepares»
only water)
During the The water is over
preparation of the
formula is only
The water tank
a dry milk mixture
is not installed
poured (the machine
correctly
«prepares» only
the mixture)
EN
Check if there is water in the water tank
and press the «Warm water» button − the
machine will check all water feed systems
Check O/I switch, make sure that it is
switched on
Check the cable continuity.
Check if the cable is plugged into the outlet
Reinstall the funnel
Make sure that the container is installed
in such a way that the container ledge
coincides with the groove (slot) on the
main unit, as shown on Picture 1, item 2
(2.1–2.6). Ensure that the container is
firmly seated in the block, and that the
teeth of the container shaft and the main
unit do not hit each other (are in bond).
If necessary, rotate the container shaft
manually and reinsert the container.
Check if the container for the mixture is
correctly assembled.
Make sure that the ledge of the funnel lid
coincides with the groove on the funnel
body, as shown on Picture 1, item 7.
Make sure that the funnel is firmly seated,
until it stops in the block
Fill the container with water, not exceeding
the MAX mark
Make sure that the ledge on the body
of the water container is firmly inserted in
the groove (slot) on the main unit case and
is inserted into the lower base on the main
unit until it stops.
Press button «Warm water» to check
the water supply. Repeat until the water
begins to flow normally
63