Agu PMBF2 Mode D'emploi page 29

3. Install the water container (pic. 1, item 4). Note that the ledge on the water
container body must be firmly inserted in the groove (slot) on the main
unit case, and the container must be fully inserted into the lower base on
the main unit. Fill the container with water, not exceeding the MAX line.
ATTENTION
The water temperature should be a few degrees below the formula
preparation temperature; otherwise, the machine will be in a standby
mode until the water cools. In this case, the indicator of the button «Warm
water» will flash. For correct operation of the machine, use baby (bottled)
boiled water at room temperature, about 25 °C.
4. Install the additional container on the water tank (pic. 1, item 5).
5. Close the additional container with the lid (pic. 1, item 6).
6. Install the funnel (pic. 1, item 8), pre-assembling it so that the ledge of the
funnel lid coincides with the slit on the body of the funnel, as shown on
picture 1, item 7. Ensure that the funnel is firmly inserted, until it stops, in
the block.
7. Install the drip tray (pic. 1, item 10) after assembling it as shown in the
pic. 1, item 9.
ATTENTION
•
Use ONLY baby (bottled) boiled water at room temperature!
•
Do not add water warmer than 45 °C.
ADJUSTING FORMULA PARAMETERS
Before the first use of the machine, as well as before using a new formula,
it is necessary to adjust the formula parameters. Fill the machine with
water. Turn on the machine, install the water container under the funnel,
press and hold the button
parameters manually, following the instructions on page 59 or using the
AGU application following the instructions on page 56.
INSTALLING AND SETTING THE APPLICATION
ATTENTION
To work with the application, you need a mobile phone with an operating
system iOS 6.0 and higher or Android 4.5 and higher. The phone must be
connected to the Internet; a wireless connection must be enabled on the phone.
56
for 20 seconds. Configure the formula
Wireless
version 4.0 LE (compatible with the Application)
communication:
NOTES
Requirements to smart devices:
iOS: iPhone 4S or later, iOS 6.0 or later.
Android: wireless communication 4.0 or later, Android 4.5 or later.
1. Download the application.
Option a: for a direct download of the application scan the QR code.
Option b: go to PlayMarket or AppStore and type «AGU» in the
search box.
2. Launch the application.
3. Register or login with a social network.
4. Select a device to connect to «Machine Preparing Baby Formula
AGU PMBF2».
5. Enter the necessary data about the child.
EN
57