Cleaning And Care - Agu PMBF2 Mode D'emploi

6. Press the button several times to fill the system with water.
Spilt water should be poured from the water tank.
Note: when you press the button
temperature will pour out into the tank without adding a formula.
7. Click the button . Use the buttons
amount of the ready formula quantity from 30 ml to 300 ml.
8. Press the button and then set the necessary temperature of the
formula preparation using the buttons
9. Press the button a third time and set the desired formula
preparation program for a given volume of water with the buttons
from 1 to 9. Now you can prepare the formula (see «Baby
formula preparation», page 60).
ATTENTION
• Use ONLY boiled water of room temperature.
• Do not add water that is above 45 °C.
• Use only baby (bottled) boiled water!
10
OPERATING PRINCIPLES AND PROCEDURE
BABY FORMULA PREPARATION
1. Before operating the device, check the powder in the tank.
ATTENTION
In the container should be at least 30–40 grams of the mixture for the
correct preparation of the formula.
2. Fill the water tank. The volume of water must be more than the volume
of the prepared formula. The temperature of the water should be several
degrees below the formula preparation temperature; otherwise, the
machine will be in a standby mode until the water cools. In this case, the
indicator of the button «Warm water» will flash. For correct operation of the
formula, use baby (bottled) boiled water at room temperature, about 25 °C.
3. Set the container for the prepared formula under the funnel. If the
container for the prepared formula is too high and does not fit into the
space between the funnel and the tray, remove the grate of the pallet;
install the container for the prepared formula without the grate.
60
, the water of set volume and
to set the necessary
from 25 °C to 50 °C.
ATTENTION
• Use ONLY baby (bottled) boiled water at room temperature!
• Do not add water that is above 45 °C.
4. In the manual mode of operating the baby formula preparation machine
press the button . You will hear a beep signal when the formula is
ready.
5. In the mode of operating the baby formula preparation machine through
the application select the required amount of the formula and press the
«Start» button.
11

CLEANING AND CARE

If you do not use the unit for a long time:
Once in three days turn on the circulation in the system by pushing the button
. Put the water tank under the funnel beforehand.
If you are not planning to use the unit for 3 days or more, empty the water tank.
Then drain the water out of the unit's system by pressing and holding the button
for 20 seconds.
If you do not plan to use the machine for a long period of time, contact your local
service centre to prepare the unit for long-term storage.
1. During operation before the first use, flush all the detachable parts
thoroughly under a stream of warm running water (use neutral
detergents), then wipe them dry with a soft cloth or wait until it dries
completely. The recommended cleaning frequency is 1 time per day.
EN
61