Makita DMP180 Manuel D'instruction page 7

1
2 3
Unit button Minus button
gauge when you turn on the tool. If nothing is connected
to the tool, the pressure gauge displays "0".
You can set the air pressure on the pressure gauge. To
change the unit, press the unit button. To increase the
pressure value, press the plus button. To decrease the
pressure value, press the minus button. You can set the
pressure value between 20 kPa (3 PSI) and 830 kPa
(121 PSI).
1
2
Lamp Main power switch
CAUTION:
When you turn on the tool by pressing the main power
pressing the main power switch, the lamp goes out.
NOTICE:
NOTE:
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Sport ball needle
Adapter holder
Plus button
The adapters can be stored in the adapter holder of the
tool. Insert the sport ball needle into the Presta valve
adapter before attaching them to the adapter holder.
Hose holder
The hose can be attached to the hose holder of the tool.
7 ENGLISH
1 2
3
Presta valve adapter
2
1
Hose