Oscartielle ARGUS Mode D'emploi page 25

13 - Accessories
ARGUS-BRIONI2-PHOENIX2 displays can be fitted with the following accessories on request.
- Night blinds.
- Row dividers.
- Raised edges in tempered glass for display shelves.
- Shelf illumination.
- Price holders in aluminium or plastic.
- Electric defrosting (armoured resistances on the evaporator).
If you are interested in purchasing any of the above accessories, contact your nearest dealer or the manufacturer directly.
Only qualified personnel should assemble the electric defrosting units.
14 - Customer service
If you need the assistance of expert service personnel, or if any mechanical, electrical or compressor components need
to be replaced, please contact the dealer from whom you bought the unit and ask for original spare parts.
15 - Dismantling and elimination of cabinet
For environmental reasons and in compliance with the regulations in your country, separate the parts of the cabinet for
disposal and/or recycling.
All the parts that make up the cabinet are made of materials that are not classifiable as urban waste except for the
metallic parts that are not classified as special waste in most countries. As regards the parts of the refrigeration circuit,
that is the refrigerating gas and lubricating oil, these should not be disposed of carelessly and can be recycled by
specialized centers.
This product contains HFC, namely fluoridated gasses, a refrigerating gas with a high Global Warming Potential
(GWP) regulated by the Kyoto protocol.
The gas contained in foam polystyrene for thermal insulation of the cabinet is (R134A).
Oscartielle equips its plug-in cabinets with the following types of refrigerating gasses:
R 134a; GWP = 1300
(100)
R 404A; GWP = 3750
(100)
This unit is hermetically sealed and the refrigerating gas load is under 3 kg.
For this reason it is not subject to the requisite of an installation booklet and periodic inspections for leakage of
the refrigerating gas (presidential Decree no. 147 of February 15th 2006, Art. 3 and 4).
16 - Manufacturer's declaration (Start-up prohibition)
The above models are also built to be assembled in line with other items of machinery to produce a machine, as defined
by Directive 2006/42/CE. Therefore, the Manufacturer hereby states that the cabinet may not be started up until the
machine in which it is incorporated or will become a part of has been identified and its compliance with the provisions of
Directive 2006/42/CE and applicable national laws has been ascertained, in other words, until the machine referred to in
this statement becomes one with the final machine.
17 – Multiplexing instructions
In order to multiplex two or more cabinets, please follow the instructions indicated below and refer to Fig. 15:
- Draw the cabinets close and adjust the feet, to obtain a perfect alignment (Ref. 1).
- Insert two iron prongs D4x40 in the aluminium top trim.
- Hook the basements using four threaded bars M8x125 and relevant nuts and washers (Ref. 2) delivered with the
cabinet.
- Remove the back panels close to the uprights.
- Join the basins screwing the proper screws in the holes drilled in the uprights (Ref. 3) as well as in the brackets (Ref.
4b) using 4 screws M8x60 and relative nuts.
- In the end assemble the back panels again.
- Join the door frameworks with screws and nuts - ref. 5, picture 15B (only for Argus Doors / Brioni 2 Doors).
18- Diagram for cables and pipe installation
Diagram for cables and pipe installation can be seen at FIG. 16.
19 - Wiring diagrams
The wiring diagrams can be seen FIG.17, 18 19 and 20.
20 - Conformity Declaration
A copy of the declaration of product conformity can be requested by filling in the form available a the internet address:
http://www.oscartielle.it/conformity
23