Programming Menu Items - Hatco Toast-Qwik ITQ Série Manuel D'installation Et D'utilisation

OPERATION

Programming Menu Items

Intelligent Toast-Qwik Conveyor Toasters offer several
®
programmable parameters to create toasting sequences
for custom menu items. Use the following information and
procedure to program menu items.
Programmable Parameters
Top Heat .... Heat output level from top elements. Setting
range is 1–100. 1 = lowest heat/lightest toast.
100 = highest heat/darkest toast.
Bot Heat ..... Heat output level from bottom elements. Setting
range is 1–100. 1 = lowest heat/lightest toast.
100 = highest heat/darkest toast.
Belt Time ... Total time product is in toasting chamber. Increasing
belt time will slow down conveyor and create darker
toast. Decreasing belt time will speed up conveyor
and create lighter toast.
Belt Dir. ...... Forward—Conveyor
continuously (standard toaster operation).
In and Out—Conveyor belt moves product into
toasting chamber, pauses for programmed Belt
Time, then reverses and moves product out of the
toasting chamber back onto the feed platform.
In and In—Conveyor belt moves product into
toasting chamber, pauses for programmed Belt
Time, then continues forward and moves product
out of the toasting chamber to the discharge toast
chute.
Length ........ Length of the product to be toasted (measured
parallel to the conveyor).
Name .......... Edit product names.
For single conveyor units: While editing product
name, use the "1" program key to move cursor
left and the "6" program key to move cursor right.
Touch the "8" program key to return name to
factory default name.
For dual conveyor units: While editing product
name, use the left-side "1" program key to move
cursor left and the right side "1" program key
to move cursor right. Touch the right-side "3"
program key to return name to factory default
name.
belt moves forward
10
Programming a Parameter
1. Make sure the toaster is
plugged into a
grounded electrical receptacle
of the correct voltage, size, and
plug configuration.
2. Move the power I/O switch
located on the back of the
toaster to the "I" (on) position.
• Graphics and software version information will appear
on the display.
3. Touch and hold the
on the touchpad control for
three seconds to activate the
toaster.
• The preheating cycle lasts
approximately 10 minutes.
When the preheating cycle is complete, the available
menu items will appear on the touchpad display.
4. Touch and hold the desired program key for three seconds.
• A password prompt will appear:
For single conveyor units, touch the "6" program key for
the password, and touch the "5" program key to accept.
For dual conveyor units, touch the right-side "1" program
key for the password, and touch the left-side "5" program
key to accept.
• The Programming menu will appear on the display
showing a list of programmable parameters.
5. Use the left-side
select the desired parameter. Refer to "Programmable
Parameters" in this section for a description of each
available parameter.
6. With the parameter highlighted, use the right-side
keys to change the parameter.
7. Continue to use the left side
and highlight/select other desired parameters, followed
by the right-side
selected parameter.
8. When all desired parameters have been programmed:
• For single conveyor units: Touch the "5" program key to
save the changes; Touch the "10" program key to cancel
all changes.
• For dual conveyor units: Touch the left-side "5" program
key to save the changes; Touch the right-side "5"
program key to cancel all changes.
NOTE: After programming a menu item on a dual conveyor
toaster, the menu item will be the same program key
number with the same parameters for both conveyors.
English
properly
Power I/O
Switch
key
Preheating 10:00
keys to scroll through and highlight/
keys to scroll through
keys to change the setting of the
Form No. ITQM-0317