H.Koenig KM68 Manuel D'utilisation page 11

Operation with Biscuit Attachment (see illustration D)
1. Please follow points 1 to 4 as described under "Initial Operation".
2. Unscrew the biscuit attachment and select the desired biscuit cutter.
3. Put the mixture on to the filling tray and the filler neck.
4. Please ensure that the function switch (7) is turned to "Off".
5. Connect the device to a 230 V, 50 Hz safety contact power socket.
6. Turn the mincer on by the screw (16).
7. If necessary, push the mixture further down with the pusher (18). Do not touch with your fingers.
8. Hold the elongated mixture at the exit and cut it off at the desired length.
Salad Express
Initial Operation - General
1. Remove the cover (2a) from the helix drive and take out the screw (16).
2. Place the salad express housing (21)with the filler neck facing upwards into the spiral drive and turn the
screw (16) clockwise until it is closed.
3. Choose a cylinder cutter [ Fine Rasping (23a) / Coarse Rasping (23c) or Slice Cutter (23b)] Place the cylinder
cutter into the salad express housing with opening facing to the front.