Makita SG1251 Manuel D'instruction page 8

Mount the diamond wheel carefully onto the spindle.
Align the directions of the arrow on the diamond wheel
and the tool. Install space rings, the other diamond
wheel and the lock nut.
Tighten the lock nut securely clockwise with the lock nut
wrench while pressing the shaft lock.
2
015047
Return the blade case and tool base to the original
position and tighten the bolt to secure them.
Adjusting the front handle angle
2
015042
Loosen the two bolts on both sides of the front handle
with the hex wrench. Move the front handle to your
desired angle and tighten the two bolts firmly.
NOTE:
When the handle cannot be moved easily, loosen
•
the bolts furthermore.
Shifting the front handle sideways
1
1. Bolt (Short)
2. Cam
3. Bolt (Long)
015043
Remove the two bolts on both sides of the front handle
with the hex wrench. Change the position of the cam.
Insert the longer bolt to the side close to the cam and
the shorter one to the opposite side. Tighten the two
bolts firmly.
1. Blade case
1
2. Diamond wheel
1. Front handle
1
2. Bolt
2
2
3
Connecting to vacuum cleaner
1
3
015046
When using Makita dust collector, connect the hose for
the vacuum cleaner directly to the dust nozzle.
NOTE:
The dust nozzle can be rotated freely so that you
•
can use it at any angle according to your operation.
Hex wrench storage
1
004508
When not in use, store the hex wrench to keep it from
being lost.
OPERATION
CAUTION:
Be sure to pull the tool when cutting a workpiece.
•
Use this tool for straight line cutting only. Cutting curves
•
can cause stress cracks or fragmentation of the diamond
wheels resulting in possible injury to persons in the vicinity.
After operation, always switch off the tool and wait
•
1
until the diamond wheels come to a complete stop
before putting the tool down.
Hold the tool firmly with one hand on the switch
•
handle and the other hand on the front grip when
performing the tool.
015076
8
1. Dust nozzle
2. Vacuum cleaner
2
3. Hose
1. Hex wrench
2
2. Front handle