Functional Description - Makita SG1251 Manuel D'instruction

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function
on the tool.
Shaft lock
CAUTION:
Never actuate the shaft lock when the spindle is
•
moving. The tool may be damaged.
1
015036
Press the shaft lock to prevent spindle rotation when
installing or removing accessories.
Sighting
1
004497
There are notches on the front and rear of the base.
This is helpful for an operator to follow a straight cutting
line.
Adjusting the grooving depth
015099
The grooving depth can be adjusted between 0 mm and
30 mm (0" and 1-3/16").
Loosen the clamping screw and adjust the pointer to
your desired depth graduation on the scale.
Then tighten the clamping screw firmly.
1. Shaft lock
1. Notch
1. Scale
1
2. Clamping screw
2
Switch action
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
1
015038
For tool with lock button
CAUTION:
Switch can be locked in "ON" position for ease of
•
operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger, push in
the lock button and then release the switch trigger.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
For tool with lock-off button
CAUTION:
Do not pull the switch trigger hard without pressing
•
in the lock-off button. This can cause switch
breakage.
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided.
To start the tool, depress the lock-off button and pull the
switch trigger. Release the switch trigger to stop.
For tool without lock button / lock-off button
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
Electronic function
The tools equipped with electronic function are easy to
operate because of the following features.
Constant speed control
Electronic speed control for obtaining constant speed.
Possible to get fine finish, because the rotating speed is
kept constant even under load condition.
Soft start
Soft-start feature minimizes start-up shock, and makes
the tool start smoothly.
6
1. Switch trigger
2
2. Lock button /
Lock-off button