Acoustic Signals; Before First Use - AEG FAVORIT 88060 VI0P Notice D'utilisation

26 www.aeg.com
The use of this option decreases the en-
ergy consumption (up to 25%) and the
programme duration.
The dishes can be wet at the end of the
programme.

5.4 Acoustic signals

The acoustic signals operate in these
conditions:
• The programme is completed.
• The level of the water softener is ad-
justed electronically.
• The appliance has a malfunction.
Factory setting: On.
It is possible to deactivate the
acoustic signals.
Deactivating the acoustic signals
1. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode, refer to
"Setting and starting a programme".
2. Press and hold, at the same time
touchpads (4) and (5) until the indica-
tors of touchpads (3), (4), (5) and (6)
flash.
3. Press touchpad (5),
• The indicators of touchpads (3), (4)
and (6) go off.
• The indicator of touchpad (5) con-
tinues to flash.
• The display shows the current set-
ting of the acoustic signals.

6. BEFORE FIRST USE

1. Make sure that the set level of the
water softener agrees with the water
hardness in your area. If not, adjust
the water softener. Contact your local
water authority to know the water
hardness in your area.
2. Fill the salt container.
On
4. Press touchpad (5) to change the set-
ting.
5. Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
5.5 Setting the TimeBeam
colour
Nine colours are available for this light
beam. You can change the colour or de-
activate it.
1. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode, refer to
"Setting and starting a programme".
2. Press and hold, at the same time
touchpads (4) and (5) until the indica-
tors of touchpads (3), (4), (5) and (6)
start to flash.
3. Press touchpad (6).
• The indicators of touchpads (3), (4)
and (5) go off.
• The indicator of touchpad (6) con-
tinues to flash.
• The display shows a number and
the letter C. Each number is rela-
ted to a different colour (0C =
TimeBeam deactivated).
4. Press touchpad (6) again and again
to change the colour.
5. Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Processing residues can stay in the
appliance. Start a programme to re-
move them. Do not use detergent
and do not load the baskets.
Off