Ribimex Ribiland PRMPP043 Traduction Des Instructions D'origine page 31

Blockage of the suction
filter screen
Higher place than that of the
water source pump
Too far away or too high
from the water supply
Blockage inside the pump
Small amount of
Wear-out of the turbine
delivery
Too low speed of the engine
Low output power of the
engine
Looseness of the assembled
screw bolt
Water is leaking
Damage or cracking of the
out from the
buckle
pump.
Wear-out or damage of the
mechanical seal
Clean the suction filter screen.
Get the pump close to the water source.
Get the pump close to the water supply spot, as close as
possible.
Disassemble and repair the pump. (Competent servicing
dealer)
Replace the turbine. (Competent servicing dealer)
Throttle up.
Inferior fuel--replace and check.
Check whether the air filter is blocked--clean.
Check whether the fuel filter is blocked –clean.
Adjust and repair the carburetor. (Competent servicing
dealer)
Disassemble and repair the engine. (Competent servicing
dealer)
Increase the torsional force.
Replace the buckle. (Competent servicing dealer)
Replace the mechanical seal. (Competent servicing dealer)
- 28 -