Read This First - Hapro Luxura X5 Mode D'emploi

Read this first

The information contained in this manual regarding assembly and operation should be followed in full. Failure to do so may render the product warranty or liability on behalf of the supplier
null and void. If there is any uncertainty as to whether the instructions contained in this manual have been followed properly and entirely, you should contact the supplier of the sunbeds.
1 Contact your authorised Hapro dealer imme-
diately if this unit does not function as out-
lined in this manual.
2 Do not operate this unit in humid spaces.
3 Always make sure the fuses can carry the load.
This unit has to be protected by ground fault
circuit interrupter (GFCI) of 0.03A.
4 Always disconnect the power to the unit at the
wall breaker (isolator) when servicing or clean-
ing the in-side construction of the cabine.
Maintenance for which the procedure is not
described in this manual should only be car-
ried out by a qualified electrician. Never clean
the electrical components with fluids.
5 Ensure that the canopy does not touch the
wall when opened.
6 Prevent the acrylic sheets from coming into
contact with sharp objects.
7 This unit may not be operated if:
• the user is not wearing protective uv-
goggles
• the blue or white facial glass is cracked or
broken
• the acrylic panel in the canopy and/or
bench is missing
• one or more of the fans in the unit are not
functioning properly
• the timing mechanism is not functioning
properly
• the temperature inside the cabin is 30°C
or higher
4
8 To ensure maximum tanning effectiveness,
change the acrylic sheet after every 1200
hours of operation.
9 To ensure maximum tanning effectiveness, re-
place the lamps and the facial tanning lamps
according to manufacturer´s instructions.
10 Check local regulations to find out the proper
procedure for lamp disposal.
11 Note: only a special acrylic cleaner may be
used to clean the acrylic sheet. Never use
cleaners that contain alcohol, as these can
damage the acrylic sheet.
12 The UV-type of the tanning unit is indicated
on the specification sticker.
13 Ultraviolet radiation from the sun or UV
appliances can cause skin or eye damage.
These biological effects depend upon the
quality and quantity of the radiation as well as
the skin and eye sensitivity of the individual.
14 Excessive exposure may cause skin to burn.
Excessive repeated exposure to ultraviolet
radiation from the sun or UV appliances may
lead to premature ageing of the skin as well as
increase risk of skin tumours.
15 The unprotected eye may develop surface
inflammation and in some cases, after a
cataract operation for example, damage may
accur to the retina after eccessive exposure.
Cataracts may develop after prolonged expo-
sures.
16 If the supply cord is damaged, it must be
replaced by the manufacturer or service agent
or a similarly qualified person in order to avoid
a hazard.
17 To replace lamps and starters, remove by
turning a quarter turn to the left. Placement of
new lamps and starters is done in the reverse
to the above mentioned procedure.
18 When installing the equipment, follow the
recommended minimum distances listed in
the "Dimensions / Placement" chapter.
19 Clean the dust filters after every 50 hours of
use. Regularly check the dust filters.
20 Children should be supervised to ensure that
they do not play with the tanning unit.
21 Non-users, especially children, must not be
present when the appliance is being operat-
ed.
Please consult enclosed tanning
schedule for advised tanning times.
Repairs may only be carried out by qualified
Always disconnect the main power at the
circuit breaker before servicing or repairing
Note
personnel.
the unit.