Hapro Luxura X5 Mode D'emploi page 12

(optional) The "air conditioning" button is used to switch the airco on and off. It will be turned on by default at the
start of each tanning session.
Note
The air conditioning can be switched off by
pressing the button for
at least 3 seconds.
If the "air conditioning" button is pressed during cool-down, the display
Once the air conditioning has been switched
will show the remaining cooling down time.
off, it must cool down for 3 minutes before
it can be switched on again.
(optional) The "Xsens" button switches the Xsens fragrance on and off. It
will be switched on by default at the start of each tanning session.
The "face tanners max" button is used to switch both the outside two as the centre face tanner(s) to their maximum
setting.
The "face tanners min" button is used to switch both the outside two as the centre face tanner(s) to their minimum
setting.
Setting 1: All face tanners on minimum setting
Setting 2: Centre face tanner(s) on maximum, outside face tanners on minimum setting
Setting 3: All face tanners on maximum setting
Note
The "increase face cooling" button increases the face cooling.
The face tanners are switched off by
pressing the "face tanner min"
button for 3 seconds.
The "decrease face cooling" button decreases the face cooling.
When the tanning session starts face
tanning setting 1 will be active.
The face cooling can be set to 4 different levels.
The "increase body cooling" button is used to increase the body cooling.
The "decrease body cooling" button is used to decrease the body cooling.
The body cooling can be set to 4 different levels.
12