Agri-Fab 45-03201 Notice D'utilisation page 7

12. (Figure 9) Assemble the height adjustment handle
to the inside of the bracket on the end of the height
adjustment tube. Use two 5/16" x 1" hex bolts (E), 5/16"
flat washers (K) and 5/16" nylock nuts (J). Tighten.
13. (Figure 9) Assemble the grip (W) onto the height
adjustment handle.
5/16" x 1" HEX BOLT (E)
5/16" FLAT WASHER (K)
5/16" NYLOCK NUT (J)
14. (Figure 10) Assemble onto a 5/16" x 1-1/4" hex bolt
(D) in the order listed, a 5/16" flat washer (K), the pivot
bushing (S), the height adjustment strap and the spacer
bushing (T). Insert the bolt through the upper part of
the double hole in the end of the sweeper housing and
secure it with a 5/16" nylock nut (J). Tighten.
GRIP (W)
HEIGHT
ADJUSTMENT
HANDLE
5/16" NYLOCK NUT (J)
SPACER BUSHING (T)
HEIGHT ADJUSTMENT
STRAP
PIVOT BUSHING (S)
5/16" FLAT WASHER (K)
5/16" x 1-1/4"
HEX BOLT (D)
ENGLISH
15. (Figure 11) Place the star washer (L) between the
height adjustment handle and the height adjustment
strap. Insert the 5/16" x 1" carriage bolt (F) through
the height adjustment handle, the star washer and the
height adjustment strap. Assemble a 5/16" flat washer
(K) and the plastic knob (X) onto the end of the bolt.
9
STAR WASHER (L)
(between strap and handle)
10
7
5/16" x 1"
CARRIAGE BOLT (F)
5/16" FLAT
WASHER (K)
PLASTIC KNOB (X)
11