Technical Specifications - LENCO DAR-051 Mode D'emploi

Technical Specifications

Input
Output power
Speaker Driver
Battery in remote control
DAB Frequency range
FM Frequency range
Bluetooth Frequency range:
Bluetooth Version:
EIRP/RF output power:
Power consumption
Power consumption (standby)
Operating Temperature
Operating position
Dim. unit
Weight
Remark: The maximum connection distance is around 10 meters. Please place your Bluetooth device as close as
possible to this device to avoid connection getting disturbed.
WARNING! Risk of hearing impairment
• Set a low volume on the playback device before connecting headphones.
• Avoid excessive volume, particularly over extended periods or frequent
use. Excessive volume can result in permanent hearing impairment.
About the disks
AC 100-240V ~ 50/60Hz
2 x 10 W RMS
4Ω, 15W
CR2025 Li-Mn battery, 3.0V, 150mAh
174.928 - 239.200 MHz
87.5 - 108 MHz
2402 - 2480MHz
V5.0
<3.56dBm
Max 28W
< 1W
0°C-35°C
Horizontal
430 x 215 x 145mm
3.33KG
Handling
Do not touch the underside of disks.
Hold disks by the edges to avoid leaving fingerprints on the surface. Any
dust, fingerprints or scratches may cause a malfunction.
Never affix a label or sticky tape to the disk.
Storage
Put disks back in their case after use.
Never expose disks to direct sunlight or heat sources. Never leave disks inside a
car parked in full sunlight.
Cleaning
Use a clean, soft, lint-free cloth to clean the disk, working from the center
outwards in a straight line. Do not use solvents such as petrol, thinners,
commercially available cleaners or antistatic sprays for vinyl disks.
- EN 18 -