Installation Instructions - Built In - Danby Silhouette Professional DAR055D1BSSPRO Manuel Du Propriétaire

INSTALLATION INSTRUCTIONS - BUILT IN
TOOLS YOU WILL NEED
Safety goggles
Electric drill with hole bit
Gloves
PREPARING THE ENCLOSURE
ELECTRICAL REQUIREMENTS
The appliance must be connected to an
individual, properly grounded electrical outlet
protected by a 15 or 20 ampere circuit breaker
or time delay fuse.
• Remove the screws (see Fig.1. (B)) 4 screws total)
from the compressor back cover and take out the
compressor cover (see Fig.1. (A)) before installing
the unit. Please keep all components that you take
out from the back of the unit. (Fig.1)
• Keep the spare caster
• It is recommended that you do not install the outdoor
all refrigerator into a corner (i.e. directly beside a
wall). This is to allow the door(s) to have a greater
then 90° opening swing. A limited door swing will
prevent the shelves from sliding out as intended, and
may lead to damaging the door gasket.
• The rough cabinet opening must be on a level
floor area and at least 23 1/16" deep by 24 1/16"
wide. The opening should also have a height of at
least 34 9/16".
• The electrical outlet may be positioned from within
either side of the adjacent cabinetry, or the rear of
the shaded area (as shown in Fig 2.).
• If the electrical outlet is located inside the adjacent
cabinetry, cut a 1-1/2" diameter hole to admit
the power cord. If the cabinet wall is metal, the hole
edge must be covered with a bushing or grommet.
Tape measure
Carpenter square
Flashlight
Level
Fig.3
NOTE:
While performing installations
described in this section gloves
and safety glasses or goggles
should be worn.
Fig.1
A
B
Fig.2
1 1
/ " dia hole
2
*If electrical outlet
is in adjacent cabinetry
Cabinet is
square
and plumb
NOTE:
This unit is front breathing.
Do not block the front air vent. Blockage
of this vent will result in high operating
temperatures and system failure. (Fig.3)
3
BACK
/
1 "
23
16
min
24 / "
1
16
3
1 / "
16
Electrical Access
6"
"
9 /
34
16
From underside
of countertop
to floor