Installation - Sharp SJ-WS320T Mode D'emploi

INSTALLATION

WARNING
■ Do not install the refrigerator in a damp or wet location
as this may cause damage to the insulation and a
leakage . Condensation may also build on the outer
cabinet and cause rust .
■ In order to prevent possible electric shock, connect
the receptacle of earth to the earth terminal properly .
1
Keep adequate ventilation space around the refrigerator.
• The figure shows the minimum required space for
installing the refrigerator. The measurement condition
of power consumption is conducted under a different
space dimension.
• By keeping greater space, the refrigerator may be
operated under a less amount of power consumption.
• If using the refrigerator in the smaller space dimension
than the below figure, it may cause the temperature
rise in the unit, loud noise and failure.
90mm
or more
60mm 60mm
or more or more
Free standing type
2
Use the two front adjustable feet, to ensure that the
refrigerator is positioned firmly and flat on the floor.
3
Clip the foot cover (supplied inside the refrigerator
compartment) in the position on the front of the two
adjustable feet.
NOTE
• Position your refrigerator so that the plug is accessible.
• Keep your refrigerator out of direct sunlight.
• Do not place next to heat generating appliance.
• Do not place directly on the ground.
Provide suitable stand.
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
6
60mm
or more
1350mm
1040mm
SJ-RP320T SJ-WS320T
SJ-RM320T SJ-WP320T
SJ-RP360T SJ-WS360T
SJ-RM360T SJ-WP360T
Adjustable foot
Foot cover
Before transporting
• Wipe up water in the evaporating pan.
Before wiping up the water, wait more than 1 hour after
pulling out the plug because the refrigeration cycle
equipment is extremely hot.
(The evaporating pan is located on the rear of the product.)
NOTE
• Do not bend or damage the ductwork located on the inside of
the evaporating pan. It may cause failure.
When transporting
• The casters allow the refrigerator to move back and forth.
• Carry the refrigerator by holding the handles located on
the rear and the bottom.
Casters
(4pcs.)
When the door is heavy to open
(Only for SJ-WS320T, SJ-WP320T, SJ-WS360T, SJ-WP360T)
When one side door is heavy
• When the left side is heavy, lower the right side adjustable
foot.
(Until the opposite side adjustable foot is slightly off-ground.)
Heavy
• When the right side is heavy, lower the left side adjustable
foot.
When both sides are heavy
• When the refrigerator is tilted backwards, insert a wooden
board (with relatively large width), etc. between the rear of
the refrigerator and the floor to adjust the tilting.
Front
Reversible door
(Only for SJ-RP320T, SJ-RM320T, SJ-RP360T, SJ-RM360T)
It is possible to change the door to left side opening. To modify the
door a REFRIGERATOR HINGE KIT (for left side opening) will be
required, SJ-LR320TD. For details of the kit and the modification
work, please contact the service agent approved by SHARP.
CAUTION
SHARP recommends that all modification work
will be carried out by the approved service agent.
Evaporating
Pan
Adjustable
foot
Back
A wooden board
(with relatively
large width)