Horizon Fitness EX-59 Manuel Du Propriétaire page 8

ASSEMBLY STEP 3
NOTE: Be
careful not
to pinch any
wires while
attaching the
console mast.
8
CONSOLE MAST
CONSOLE CABLE
PRE-INSTALLED BOLTS
AND WASHERS
MAIN FRAME
CRANK
PEDAL ARM
GUIDE RAIL
PEDAL ARM WHEEL
Open HARDWARE BAG 3.
A
Carefully pull the CONSOLE CABLE through
B
the CONSOLE MAST using the twist tie
located inside the CONSOLE MAST.
Attach CONSOLE MAST to MAIN FRAME
C
using PRE-INSTALLED BOLTS AND
WASHERS.
Slide WAVY WASHER (G) over CRANK
D
followed by PEDAL ARM as shown. Rest
PEDAL ARM WHEEL on GUIDE RAIL.
Attach the PEDAL ARM to the CRANK using
E
1 FLAT WASHER (H), 1 SPRING WASHER (I)
and 1 BOLT (J).
WAVY WASHER (G)
FLAT WASHER (H)
Repeat steps D–E on the opposite side of the
F
SPRING WASHER (I)
elliptical.
BOLT (J)
HARDWARE BAG 3 CONTENTS:
WAVY FLAT SPRING
WASHER (G) WASHER (H) WASHER (I)
22.5 mm 20 mm 15 mm
Qty: 2 Qty: 2 Qty: 2
BOLT (J)
20 mm
Qty: 2