Starting A Program; Program Change; Program End - AEG LAVATHERM M8C952BS Notice D'utilisation

To activate or deactivate an option touch
the relevant button or a two button
combination.
its symbol appears on the display or the
led above the corresponding button
lights up.
8.7 Child lock option
The child lock can be set to prevent
children from playing with the appliance.
The child lock option locks all touch
buttons and the program dial (this option
does not lock the On/Off (Marche/
Arrêt) button).
You can activate the child lock option:
• before you touch the Start/Pause
(Départ/Pause) button - the
appliance cannot start
• after you touch the Start/Pause
(Départ/Pause) button - programs
and option selection is unavailable.
Child lock option activation:
1. Turn the dryer on.
2. Select 1 of the available programs.
3. Touch and hold down 2 buttons at
the same time.
The symbol appears on the display.
4. To deactivate the child lock, touch
the above buttons again until the
symbol disappears.

8.8 Starting a program

To start the program:
Touch the Start/Pause (Départ/Pause)
button.
The appliance starts and the LED above
the button stops flashing and stays on.

8.9 Program change

To change a program:
1. Push the On/Off (Marche/Arrêt)
button to turn the appliance off.
2. Push the On/Off (Marche/Arrêt)
button again to turn on the
appliance.
3. Set a new program.

8.10 Program end

Clean the filter and drain the
water container after each
drying cycle. (See chapter
CARE AND CLEANING.)
If the drying cycle is finished, the symbol
appears on the display. If the Buzzer
(Alarme) option is activated, the acoustic
signal sounds intermittently for 1 minute.
If you do not turn off the
appliance, the anti-crease
phase starts (not active with
all programs). Flashing
symbol signals the execution
of the anticrease phase.
Laundry can be removed
during this phase.
To remove the laundry:
1. Push the On/Off (Marche/Arrêt)
button for 2 seconds to turn the
appliance off.
ENGLISH 15
4