Resetting To Default Settings; Disposal - wtw pH 1970i Mode D'emploi

pH 1970i
Measurement
parameters
Configuration
parameters
pH S mV
I i n i
%
O mg/l
S/
m
Sal
1/
cm
Time Baud 0 9 n o
C
°
Day.Month No.
%
Year Ident
ba75675e03 05/2012

Resetting to default settings

You can reset the measurement parameters and the configuration to the
delivery status separately from one another (initialization).
The following measurement parameters can be reset to the delivery status:
Measuring mode
Slope
Asymmetry
Manual temperature input
The following configuration parameters (InI) can be reset to the delivery
status:
Baud rate
Display during pH calibration
Interval 1
(automatically saved)
Interval 2
(for data transmission)
Reset procedure:
 Press <CAL> while pressing the <RUN/ENTER> key.
/ pH
 To reset the measurement parameters, use <▲> <▼> to select YES and
cm
confirm with <RUN/ENTER>, or
Sal
 Continue to the configuration parameters without resetting (InI) with the
/ K
TP
<RUN/ENTER> key.
 After the InI configuration parameters, the instrument switches to the last
active measurement mode.

Disposal

At the end of its operational lifetime, the meter must be returned to the
disposal or return system statutory in your country. If you have any questions,
please contact your supplier.
Resetting to default settings
pH
-59.16 mV/pH
0 mV
25 °C
4800
Buffer nominal value
OFF
OFF
27