Safety Instructions; General Safety - Dometic GROUP WAECO CoolMatic MDC065 Notice D'utilisation

Safety instructions

A
NOTICE!
Failure to observe this instruction can cause material damage and
impair the function of the product.
I
NOTE
Supplementary information for operating the product.
➤ Action: This symbol indicates that action is required on your part. The
required action is described step-by-step.
✓ This symbol describes the result of an action.
Fig. 1 5, page 3: This refers to an element in an illustration. In this case,
item 5 in figure 1 on page 3.
2 Safety instructions
The manufacturer accepts no liability for damage in the following cases:
 Faulty assembly or connection
 Damage to the product resulting from mechanical influences and excess
voltage
 Alterations to the product without express permission from the
manufacturer
 Use for purposes other than those described in the operating manual
2.1

General safety

DANGER!
D
 Danger of fatal injuries!
When using the device on boats: if the device is powered
by the mains, ensure that the power supply has a ground fault
interrupter circuit.
WARNING!
!
 Before starting up the device for the first time, check whether
the operating voltage and the battery voltage correspond
(see type plate).
 If the connection cable is damaged, it must be replaced to pre-
vent possible electrical hazards. Only replace a damaged con-
nection cable with a connection cable of the same type
and specifications.
24
MDC065(K), MDC090(K)
EN