Commands And Adjustaments; On/Off Button - Urmet 1092 Manuel D'utilisation

7

COMMANDS AND ADJUSTAMENTS

ON/OFF BUTTON [1]

VOLUME + ADJUSTMENT BUTTON / RIGHT ADJUSTMENT [4]
VOLUME - ADJUSTMENT BUTTON / LEFT ADJUSTMENT [5]
OSD MENU BUTTON [3]
UP ADJUSTMENT BUTTON [5]
DOWN ADJUSTMENT BUTTON [2]
INPUT SIGNAL (AV / PC / HDMI) SELECTION BUTTON [2]
BNC VIDEO INPUT [13]
AUDIO INPUT / OUTPUT (AUDIO PC) [11]
HDMI INPUT [8]
PC INPUT (VGA) [7]
POWER CONNECTOR (DC) [6]
Plug the power wire of the adapter provided into the respective DC.
ON/OFF BUTTON [7]
This is used to switch the monitor on and off. The green LCD lights up when the monitor is on.
IMPORTANT NOTE
If the following message appears on the monitor after pressing the button (7):

It means that a not connected video signal has been selected as input. To select the desired signal) press the button (7)
"AV/PC/HDMI" and select the desired item with the buttons (5-6) "DOWN" and "UP". Press the button "VOL-" or "VOL+"
(2-3) to confirm. The type of selected signal will be displayed on the top left of the page.
IMPORTANT NOTE
If the input signal is not present, the OSD menu is not active.
DS1092-181A
6
7
8
9
11
12
NO SIGNAL
16
OUT
IN
13
1
2
3
4
5