Kenmore 106.7300 Série Guide D'utilisation Et D'entretien page 25

ICE AND WATER Possible Causes and/or Recommended Solutions
Water is leaking or NOTE: After dispensing, a few additional drops of water are normal.
dripping from the
dispenser
Water is leaking
from the back of the
refrigerator
Water from the NOTE: Water from the dispenser is chilled to 50°F (10°C).
dispenser is
not cool enough
(on some models)
Glass was not held under the dispenser long enough - Hold the glass under the dispenser for 2 to 3 seconds
after releasing the dispenser pad/lever.
New installation, or water filter was recently installed or replaced - Air in the water lines causes the water
dispenser to drip. Flush the water system to remove the air in the water lines. See "Water and Ice
Dispensers."
Residual ice in the dispenser chute is melting - Make sure the ice chute is free of ice shavings or pieces.
Water line connections are not fully tightened - Make sure all connections are firmly tightened. See
"Connect Water Supply."
New installation - Allow 24 hours after installation for the water supply to cool completely.
Recently dispensed a large amount of water - Allow 24 hours for the new water supply to cool completely.
Water has not been recently dispensed - The first glass of water may not be cool. Discard the first glass of
water dispensed.
Refrigerator is not connected to a cold water pipe - Make sure the refrigerator is connected to a cold water
pipe. See "Water Supply Requirements."
25