Cembre HT-TC041N Notice D'utilisation Et Entretien page 5

2.6.1) Lower blade:
– Remove locking pin (57) and open tool head.
– Pump the moveable handle (52) to make the lower blade (24) advance until spring pins (35) are
visible on ram (22).
– Remove spring pins (35 and 88) using a drift and remove the lower blade.
– Insert the new blade and secure with spring pins.
B B
EFORE CLOSING THE TOOL HEAD EFORE CLOSING THE TOOL HEAD
OTHERWISE THE BLADE MAY STRIKE AND DAMAGE THE LOWER BLADE EDGE OTHERWISE THE BLADE MAY STRIKE AND DAMAGE THE LOWER BLADE EDGE
2.6.2) Upper blade:
– With the lower blade (24) fully retracted, the tool head closed and the locking pin (57) fully secured,
hold the tool on the blade spacer (33) or (29) in a bench vice (fi g. 3).
– By an 8 mm wrench, unscrew 4-set pins (30),remove the two holding plates (32) and the upper
blade (28) noting the position of the cutting edge bevel.
– Insert the new blade, noting the position of the cutting edge bevel.
– Fit the 2 holding plates (32) and secure with 4-set pins (30).
3. WARNING
The tool is robust and requires very little daily maintenance.
Compliance with the following points, should help to maintain the optimum performance of the tool:
3.1) Accurate cleaning
Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be wiped with a clean cloth, taking care to remove any residue,
especially close to pivots and moveable parts.
3.2) Storage
(Ref. to Fig. 5)
When not in use, the tool should be stored and transported in the plastic case, to prevent damage.
The plastic case (VAL P7), has dimensions 727x202x115 mm (19.5x9.84x3.94 in.) and weight 1,3 kg
(17.2 lbs).
3.3) Head rotation
For ease of operation, the tool head can rotate through 180°.
D D
O NOT ATTEMPT TO TURN THE HEAD IF THE HYDRAULIC CIRCUIT IS PRESSURISED O NOT ATTEMPT TO TURN THE HEAD IF THE HYDRAULIC CIRCUIT IS PRESSURISED
5
, ,
RELEASE THE OIL PRESSURE AND RETRACT THE LOWER BLADE RELEASE THE OIL PRESSURE AND RETRACT THE LOWER BLADE
ENGLISH
. .
. .
, ,