Removing/Inserting The Battery - Milwaukee M18 FUEL 2866-20 Manuel De L'utilisateur

ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.

Removing/Inserting the Battery

To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove battery pack before
WARNING
changing or removing accessories.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Only use accessories specifically
WARNING
recommended for this tool. Others
may be hazardous.
Installing and Removing Bits
1. Remove battery pack.
2. Grasp the nose cone firmly and pull away from
the tool.
3. Remove and replace the bit in bit holder.
4. Push the nose cone onto the tool until it snaps
into place.
NOTE: Depth adjustments should be reset after
changing bits.
OPERATION
To reduce the risk of injury, always
WARNING
wear proper eye protection marked
to comply with ANSI Z87.1.
When working in dusty situations, wear appro-
priate respiratory protection or use an OSHA
compliant dust extraction solution.
Using the Control Switch
The control switch may be set to three positions:
forward, reverse and lock. Always allow the motor
to come to a complete stop before using the control
switch to avoid damage to the tool.
For forward (clockwise) rotation, push the control
switch from the right side of the tool. Check the
direction of rotation before use.
For reverse (counterclockwise) rotation, push the
control switch from the left side of the tool. Check
direction of rotation before use.
To lock the trigger, push the control switch to the
center position. The trigger will not work while the
control switch is in the center locked position. Always
lock the trigger or remove the battery pack before
performing maintenance, changing accessories,
storing the tool and any time the tool is not in use.
To reduce the risk of injury, keep
WARNING
hands away from the bit and all
moving parts.
Auto-Start Mode
In Auto-Start mode, the motor will not start until pres-
sure is placed on the bit. Press the auto-start button
to turn auto-start on and off. The auto-start indicator
will light. Auto-start will remain on for 2 hours after
last use unless turned off.
Auto-Start ON: When the trigger is pulled, the motor
remains off until pressure is applied
to the bit. With pressure, the motor
turns on and the bit spins.
Auto-Start OFF: When the trigger is pulled, the motor
runs but the bit does not spin until
pressure is applied.
Trigger Lock-On
1. To lock the trigger ON for continuous use, pull the
trigger and slide the lock up. The LED will remain
on while the trigger is locked on.
2. To turn OFF the tool, pull and release the trigger.
Starting, Stopping and Controlling Speed
1. To start the tool, grasp the handles firmly and
pull the trigger.
NOTE: An LED is turned on and remains on when
the trigger is pulled or locked on in both auto-start
ON and OFF modes. LED will go off about 9 sec-
onds after trigger is released.
2. Apply pressure to the bit to begin driving.
3. To vary the speed, increase or decrease the pres-
sure on the trigger. The further the trigger is pulled,
the greater the speed.
4. To stop the tool, release the trigger. Make sure
the tool comes to a complete stop before laying
the tool down.
4