Pioneer PDP-S29-LR Mode D'emploi page 12

③ Mount the display on the wall.
* Mount the display on the wall following the
procedure described in the wall mount unit's
installation instructions.
* Insert the speaker cords and signal cables before
mounting the speakers.
In some cases it may be difficult to connect them
after mounting the speakers.
④ Catch the hook at the top of the speaker onto the
M6 screw that was partially fastened in ② above,
line up the hole in the speaker's hook with the screw
hole in the installation piece for the bottom side,
then partially fasten using the included M6 screw.
⑤ Fully tighten the four partially tightened screws.
* Gently press the speakers against the display
when tightening the screws.
WARNING
● It is also possible to mount the speakers on the display
before mounting the display on the wall. When doing this,
however, be sure to hold the display when moving and
mounting it. If you hold onto the speakers when moving
or mounting the display, the display may fall, resulting in
injury.
E-5
〔M6〕