Performance Data - Omnifilter CBF1 Instructions D'installation

PERFORmANCE dATA

model CbF1 Series A and CbF3 Series b
Important Notice: Read this performance data and compare
the capabilities of this system with your actual water treatment
needs. It is recommended that, before installing a water treatment
system, you have your water supply tested to determine your
actual water treatment needs.
This system has been tested according to NSF/ANSI 42 and 53 for
reduction of the substances listed below. The concentration of the
indicated substances in water entering the system was reduced
to a concentration less than or equal to the permissible limit for
water leaving the system, as specified in NSF/ANSI 42 and 53.
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate disinfection
before or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
NOTE: The contaminants or other substances removed or
reduced by this water treatment device are not necessarily in your
water. Filter must be maintained according to manufacturer's
recommendations, including replacement of filter cartridges.
Model CBF1 Series A
Influent Challenge
Substance
Concentration
Standard 42
Chlorine 2.0 mg/L ± 10%
Particulates at least 10,000
(0.5–<1µm) - Class I particles/mL
Standard 53
Cysts Minimum 50,000/L
Flow rate = 1 gpm (3.8 Lpm) Capacity = 1,000 gallons (3,800 L) or 12 months
Testing was performed under standard laboratory conditions, actual performance may vary.
Model CBF3 Series B
Influent Challenge
Substance
Concentration Product Water
Standard 42
Chlorine 2.0 mg/L ± 10%
Particulates at least 10,000
(0.5–<1µm) - Class I particles/mL
Standard 53
Cysts Minimum 50,000/L
10 7 to 10 8 fibers/L
Asbestos > 10 micrometers
in length
Lead (pH 6.5) 0.15 mg/L
Lead (pH 8.5) 0.15 mg/L
Mercury (pH 6.5) 0.006 mg/L
Mercury (pH 8.5) 0.006 mg/L
Chloroform (VOC 0.300 mg/L
surrogate) ± 10%
Methyl tert-butyl 0.015 mg/L
ether ± 20%
Flow rate = 0.5 gpm (1.89 Lpm), Capacity = 400 gallons (1,514 L) or 6 months
Testing was performed under standard laboratory conditions, actual performance may vary.
Test Conditions
Flow Rate = as noted for filter system
Inlet Pressure = 60 psi (4.1 bar)
pH = 7.5±1
Temperature = 68°F ± 5°F (20°C ± 2.5°C)
Operating Requirements
Pressure = 30-125 psi (2.1–8.62 bar)
Temperature = 40-100°F (4.4–37.8°C)
Turbidity = 5 NTU Max.
• 6 •
Reduction Minimum Average
Requirements Reduction Reduction
≥50% 97.5%
≥85% 96%
99.95% 99.99% 99.99%
Maximum
Reduction
Permissible
Requirements Minimum
≥50%
≥85% 97.49%
99.95% 99.98% 99.99%
99% 99.82% 99.82%
0.010 mg/L 99.3% 99.3%
0.010 mg/L 99.3% 99.3%
0.002 mg/L 96.4% 96.4%
0.002 mg/L 96.5% 96.5%
0.015 mg/L 95.8%
0.005 mg/L 79.39%
CBF3: Organic Chemicals Included by Surrogate Testing
Substance
Alachor
Atrazine
Benzene
Carbofuran
Carbon tetrachloride
Chlorobenzene
Chloropicrin
2,4-D
Dibromochloropropane (DBCP)
O-dichlorobenzene
P-dichlorobenzene
1,2-Dichloroethane
1,1-Dichloroethylene
Cis-1,2-dichloroethylene
Trans-1,2-dichloroethylene
1,2-Dichloropropane
Cis-1,3-dichloropropylene
Dinoseb
Endrin
Ethylbenzene
Ethylene dibromide (EDB)
Haloacetonitriles (HAN):
Bromochloroacetonitrile
Dibromoacetonitrile
Dichloroacetonitrile
Trichloracetonitrile
Haloketones (HK):
1,1-Dichloro-2-propanone
1,1,1-Trichloro-2-propanone
Heptachlor
Heptachlor epoxide
Hexachlorobutadiene
Average
Hexachlorocyclopentadiene
Lindane
97%
Methoxychlor
Pentachlorophenol
Simazine
Styrene
1,1,2,2,-Tetrachloroethane
Tetrachloroethylene
Toluene
2,4,5-Tp (silvex)
Tribromoacetic acid
1,2,4-Trichlorobenzene
1,1,1-Trichloroethane
99%
1,1,2-Trichloroethane
90%
Trichloroethylene
Trihalomethanes (includes):
chloroform (surrogate chemical)
bromoform
bromodichloromethane
chlorodibromomethane
Xylenes (total)
Maximum permissible
Influent Challenge product water
Concentration mg/L concentration mg/L
0.050 0.001
0.100 0.003
0.081 0.001
0.190 0.001
0.078 0.0018
0.077 0.001
0.015 0.0002
0.110 0.0017
0.052 0.00002
0.080 0.001
0.040 0.001
0.088 0.0048
0.083 0.001
0.170 0.0005
0.086 0.001
0.080 0.001
0.079 0.001
0.170 0.0002
0.053 0.00059
0.088 0.001
0.044 0.00002
0.022 0.0005
0.024 0.0006
0.0096 0.0002
0.015 0.0003
0.0072 0.0001
0.0082 0.0003
0.25 0.00001
0.0107 0.0002
0.044 0.001
0.060 0.000002
0.055 0.00001
0.050 0.0001
0.096 0.001
0.120 0.004
0.150 0.0005
0.081 0.001
0.081 0.001
0.078 0.001
0.270 0.0016
0.042 0.001
0.160 0.0005
0.084 0.0046
0.150 0.0005
0.180 0.0010
0.300 0.015
0.070 0.001