Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Temperature
(Cat. No. 2206-20 only)
Never connect the Temperature
WARNING
Probe to an energized circuit.
1. Set the Rotary Dial to position.
2. Connect the K-type tempera-
ture probe to the input terminal.
The positive (+) side of Probe
should be connected to VΩ.
3. Place the probe sensor in the
desired location.
4. The reading is displayed.
When the dial is
CAUTION
set to , the room
temperature should be dis-
played. If anything else is dis-
played, something may be
wrong with the meter. Stop us-
ing the meter immediately.
HOLD Key
Data Hold Function - Freezes the value on the display.
Press the "HOLD" button to freeze the reading. The
reading will be held regardless of subsequent varia-
tion in input. HOLD is displayed with the reading. To
exit Data Hold mode, press the HOLD button again.
SMART HOLD: The meter will beep continuously
and the display will flash if the measured signal is
50 counts larger than the display reading. (However,
it can not detect across the AC and DC Voltage/
Current.)
The Data Hold readings are released
CAUTION
when the meter enters Sleep Mode.
Sleep Mode
The meter is automatically powered off in about 20
min after the last Rotary Dial or button operation. To
reset, turn the Rotary Dial to OFF. If the display is
still blank when a new Rotary Dial setting is selected,
replace the batteries.The meter does use battery
power in sleep mode. Be sure to switch the tool to
OFF to conserve battery power.
Non-Contact Voltage Detection (NCVD)
The LED may not be displayed due
DANGER
to installation condition of electri-
cal circuit or equipment. Never touch the circuit
under test to avoid possible danger even if the
LED for NCVD is not displayed.
Check the functionality of LED on a well-known
power supply prior to measurement. When the
LED doesn't light up, do
not make measurement.
NCVD indication is af-
fected by external volt-
age, and how the meter
is held or placed.
When the meter is on in
any function, the non-
contact voltage detector
will indicate with a Red
LED on the display when
an electric field exceeding
90V is detected. Place the
edge of either jaw near the
electric field.
Worklight LED ON/OFF
To turn the light on and off, press the
Over-flow indication
Any time the input exceeds the measuring range "OL"
or "-OL" is displayed.
MAINTENANCE
To reduce the risk of injury, always
WARNING
unplug the charger and remove the
battery pack from the charger or tool before
performing any maintenance. Never disassemble
the tool, battery pack or charger. Contact a
MILWAUKEE service facility for ALL repairs.
Maintaining Tool
Keep your tool in good repair by adopting a regular
maintenance program. After one year, it is recom-
mended to return the tool to a MILWAUKEE service
facility for calibration.
If the tool does not start or operate at full power with
fully charged batteries, clean the contacts on the bat-
tery door. If the tool still does not work properly, return
the tool to a MILWAUKEE service facility for repair.
To reduce the risk of personal in-
WARNING
jury and damage, never immerse
your tool, battery pack or charger in liquid or
allow a liquid to flow inside them.
Clean dust and debris from vents. Keep handles
clean, dry and free of oil or grease. Use only mild
soap and a damp cloth to clean, since certain clean-
ing agents and solvents are harmful to plastics and
other insulated parts. Some of these include gasoline,
turpentine, lacquer thinner, paint thinner, chlorinated
cleaning solvents, ammonia and household deter-
gents containing ammonia. Never use flammable or
combustible solvents around tools.
6
Cleaning
button.
Publicité
Table des Matières
