Lcd Backlight - Milwaukee 2205-20 Manuel De L'utilisateur

ASSEMBLY
To avoid an electrical hazard, turn
WARNING
the Rotary Dial to OFF and discon-
nect the test leads before opening battery com-
partment or replacing batteries.
Selecting °C or °F
1. Turn Rotary Dial to OFF and
disconnect the test leads.
2. Unscrew and remove battery
door and remove any installed
batteries.
3. Set the C°/F° switch to the
desired position.
4. Replace batteries according
to "Loading/Changing the
Batteries.
5. Close the battery door and tighten screw securely.
Loading/Changing the Batteries
Replace batteries when the Low Battery indicator
is displayed.
1. Turn Rotary Dial to OFF and discon-
nect the test leads.
2. Unscrew and remove battery door.
3. Insert two (2) AA batteries, according
to the polarity marked in the battery
compartment
4. Close the battery door and tighten
screw securely.
OPERATION
Only use MILWAUKEE test leads
WARNING
with the MILWAUKEE Fork Meters.
Inspect test leads before each use. Use meter to
run a continuity test.
Confirm the Rotary Dial is set to the correct position,
the instrument is set to the correct measurement
mode, and the Data hold function is disabled. Other-
wise, desired measurement cannot be made.

LCD Backlight

The LCD backlight will turn off after about 3 minutes
of inactivity. Push any button or turn the rotary dial to
turn the backlight on.
Making a Measurement
To avoid electrical shock: Never
DANGER
make measurement on a circuit in
which voltage over AC 1000V or DC 1000V exists.
Do not use with the Battery Cover removed.
Keep fingers behind the guards and away from
test lead tips during measurements.
1. Set the Dial to
2. Connect the red test lead to
the VΩ terminal and the black
test lead to the COM terminal.
3. AC: Connect the test leads
to the circuit under test. The
reading is displayed.
DC: Connect the red test lead
to the positive (+) side and
black test leads to the nega-
tive (-) side of the circuit under
test. The reading is displayed.
A reversed connection is indi-
cated as a negative value.
Lo-Z Low Input Impedance
(Cat. No. 2205-20 only)
Automatic voltage detection (AC
or DC).
1. Set the Dial to Lo-Z position.
2. Connect the red test lead to
the VΩ terminal and the black
test lead to the COM terminal.
3. AC: Connect the test leads
to the circuit under test. The
reading is displayed.
DC: Connect the red test lead
to the positive (+) side and
black test leads to the negative
(-) side of the circuit under test.
The reading is displayed. A re-
versed connection is indicated
as a negative value.
4
Before Use
Voltage
position.