Maintenance - Ryobi P119 Manuel D'utilisation

MODE LED
Evaluating
Flashing
charging
Flashing
charged
On
• If charger indicates "Evaluate" for longer than 30 minutes at room temperature, battery pack may be defective. Try to repeat the
conditions a second time by removing and reintalling the battery pack. If the LED status repeats a second time, try charging a
different battery.
• If a different battery charges normally, dispose of the defective pack (see battery pack operator's manual).
• If a different battery also indicates "Evaluate" for longer than 30 minutes, the charger may be defective.
NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 6 AFTER FRENch AND
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
WARNING:
To avoid serious personal injury, always remove the
battery pack from the tool when cleaning or performing
any maintenance.
GENERAL MAINTENANcE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
This product has a Three-year Limited Warranty.
Warranty details are available at www.ryobitools.com
OPERATION
Battery is being tested. If voltage is low, battery is being conditioned and will begin charging when
normal voltage is reached. If battery is hot or cold, charger will begin charging when temperature
reaches an appropriate level.
Battery is being charged.
Battery pack is fully charged and charger is in Energy Save mode.
SPANISh LANGUAGE SEcTIONS

MAINTENANcE

5 − English
AcTION
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
STORAGE
Always remove the battery pack before storing the charger
or any time the charger is unplugged.