Intended Use; Product Features; Noise/Vibration Information; Technical Data - Bosch GST 75 BE PROFESSIONAL Instructions D'emploi

Intended Use

The machine is intended for making separating cuts
and cut-outs in wood, plastic, metal, ceramic plates
and rubber while resting firmly on the workpiece. It is
suitable for straight and curved cuts with mitre angles
to 45°. The saw blade recommendations are to be
observed.

Product Features

The numbering of the product features refers to the
illustration of the machine on the graphics page.
1 Lock-on button for On/Off switch
2 On/Off switch
3 Soft grip
4 Allen key
5 Thumbwheel for stroke rate preselection
6 Vacuum connection
7 Base plate
8 Adjusting lever for orbital action
9 Switch for sawdust blowing device
10 Guide roller
11 Saw blade*
12 Contact protector
13 Dust cover for vacuuming*
14 Stroke rod
15 SDS clamping lever for saw blade release
16 Vacuum hose*
17 Extraction adapter*
18 Splinter guard*
19 Scale for mitre angle
20 Screw
21 Angle gauge**
22 Bolt hole
23 Positioning pin/mark
24 Lead for the parallel guide
25 Locking screw for parallel guide*
26 Parallel guide with circle cutter*
27 Centring tip of the parallel guide*
*The accessories illustrated or described are not
included as standard delivery.
**Commercially available (not included in the delivery
scope)

Noise/Vibration Information

Measured values
EN 60745.
Typically the A-weighted noise level of the machine is:
sound pressure level 84 dB(A); sound power level
95 dB(A). Uncertainty K=3 dB.
Wear hearing protection!
16 | English
determined according
Overall vibrational values (vector sum of three direc-
tions) determined according to EN 60745:
When sawing wood: Vibrational emission value
2
a =5.7 m/s , uncertainty K=1.5 m/s
h
When sawing sheet metal: Vibrational emission value
2
a =4.1 m/s , uncertainty K=1.5 m/s
h
WARNING
measured in accordance with a standardised test
given in EN 60745 and may be used to compare one
tool with another.
The vibration emission level will vary because of the
ways in which a power tool can be used and may
increase above the level given in this information
sheet. This could lead to a significant underestimate
of exposure when the tool is used regularly in such a
way.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given
period of work should also take into account the times
when the tool is switched off and when it is running
but not actually doing the job. This may significantly
reduce the exposure level over the total working
period.

Technical Data

Jigsaw
Article number
Stroke rate control
Stroke rate preselection
Orbital action
Rated power input
Output power
Stroke rate at no load n
Stroke
Cutting capacity, max.
– in wood
– in aluminium
– in non-alloy steel
Bevel cuts (left/right),
max.
Weight according to
EPTA-Procedure
01/2003
Protection class
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific coun-
tries, these values can vary.
Please observe the article number on the type plate of your
machine. The trade names of the individual machines may
vary.
to
2
.
2
.
The vibration emission level given in
this information sheet has been
PROFESSIONAL
3 601 E8E 0..
W
W
spm
0
mm
mm
mm
mm
°
kg
2 609 932 539 • 22.6.06
GST 75 BE
650
360
500 – 3100
23
90
20
10
45
2.3
/ II