Table des Matières
Publicité
40
4.
Suivez les instructions ci-dessous pour remplacer les orifices
1/2" Wrench
Front Burner Orifice
a
Screw each LP orifice in so the
orifice protrudes 15/16" (24mm)
(indicating full insertion).
5.
Supprimer le rivet de gauche dans le graveur et placez-le sur le côté droit (voir illustration ci-dessous).
Remove the rivet from this
hole. This burner hole is
plugged when using NG.
© Travis Industries
Rear Burner Orifice
Use a 1/2" open end wrench
to unscrew the two orifices.
c
15/16"
24mm
Index
.
Apply thread sealant to the LP
orifices prior to installation. Use
the chart below to identify the
correct orifices.
Look here for the orifice identification
Front
Rear
4091120
b
NG
LP
#50
#56
#47
#56
Place the rivet in this
hole when using LP.
100-01239_000
Publicité
Table des Matières
