Cleaning And Maintenance; Removing Mineral Deposits - Hkoenig STW26 Manuel D'utilisation

MEMORY
If the power supply has been broken off or unplug the power cord unintentionally
during operation, the appliance will be continued previous operation automatically
from the point when the disconnection occurred provided that the pause does not
exceed 10s, even without pressing any button. In the event the pause time exceeds
10, the display shows the default setting, the appliance must be re-started.

CLEANING AND MAINTENANCE

CAUTION: Be sure to unplug this appliance before cleaning. To protect against
electrical shock, do not immerse cord, plug or unit in water or liquid. After each use,
always make sure plug is first removed from wall outlet.
1) Clean all detachable parts after each use in hot, sudsy water.
2) Wipe the product's exterior surface with a soft, damp cloth to remove stains.
3) Water droplets may buildup in the area above the funnel and drip onto the product
base during brewing. To control the dripping, wipe off the area with a clean, dry cloth
after each use of the product.
4) Use a damp cloth to gently wipe the keeping warm plate. Never use abrasive
cleaner to clean it.
5) Replace all parts and keep for next use.

REMOVING MINERAL DEPOSITS

To keep your coffee maker operating efficiently, you should clean away the mineral
deposits left by the water regularly according to the water quality in your area and
the frequency use the appliance, the detail is as follows:
1. Fill the water tank with water and descale to the maximum level in the gauge of
coffee maker (the scale of water and descale is 4:1, the detail refers to the instruction
of descale. Please use "household descale", you can use the citric acid instead of the
descale (the one hundred parts of water and three parts of citric acid).
2. Place the jug on the keeping warm plate, pay attention to let center line of carage
aligns with that of brew basket.
3. Press the on/auto/off button once and the indicator in it will be illuminated red.
After a while, water will drop out automatically.
4. After percolate the equivalent of one cup and then switch off the appliance by
pressing the on/auto/off button twice. The indicator in it will be illuminated blue and
will be extinguished after 15s.
5. Leave the solution work for 15 minutes, repeat the steps of 3-5 again.
6. Turn the appliance on by pressing the on/auto/off button once and run off the
water until the water tank is completely empty.
7. Rinse by operating the appliance with water at least 3 times.