Control Panel; Before First Use; Using Your Coffee Maker - Hkoenig STW26 Manuel D'utilisation

CONTROL PANEL

BEFORE FIRST USE

Check that all accessories are complete and the unit is not damaged. Add water into
water tank to the max level and brew water for several times without coffee powder,
then discard the water. Clean all detachable parts thoroughly with warm water.

USING YOUR COFFEE MAKER

1. Open the top lid and fill the water tank with drinking water. The water level should
not exceed the maximum level marked on the water gauge.
2. Place the funnel into the funnel support and make sure the funnel is assembled
correctly. Then put the filter correctly.
3. Add coffee powder into filter. Usually a cup of coffee need a level spoon of coffee
powder, but you may adjust according to personal taste. Then close the top lid.
4. Place the jug on the keeping warm plate.
5. Plug the power cord into the outlet. The LCD will display 12:00 and the colon will
flash.
6. Press on/ off button once, the indicator in it will be illuminated red. The appliance
will begin working.
7. The brewing process can be interrupted by pressing the on/off button once at any
time during operation, the appliance will continue brewing once on/off is pressed
again.
Note: You can take out the jug, pour and serve at any time. The appliance will stop
dripping automatically. But the time cannot exceed 30 seconds.
8. Remove out jug to serve when finish brewing (about one minute later after the
coffee stops dripping out.)
Note: the coffee you get will less than the water you have added, as some water is absorbed by
coffee ground.
9. When the process is finished, if you do not want to serve immediately, keep the
coffee maker is energized, the coffee can be kept warm in the jug. The blue
background indicator will be distinguished after brewing within 15mins and display