Assembly - Reer 1901.06 Notice D'utilisation

Assembly

1
Mark the position for the rawl plug drill holes taking the minimum spacing (distance between the
drillings = 250mm) into consideraton, and insert the rawl plugs (Fig. A)
2
Assembly the screws. Hook in the radiant heater by pushing it to the right side into the arrester.
After that you have to move the device towards the bottom and to fasten the screws. (Fig. 2).
Caution: Do not touch the radiant heater during and shortly after use! (HEAT RADIATION).
3
Setting the radiant heater' s angle: The radiant heater' s angle is in nitely variable. Simply tilt it to the
desired position (Fig. 3).
4
Plug the heater into the socket (Fig. 4). The heater is now ready for use.
Caution: Do not place the power cord over the radiant heater!
• The local electrical regulations (EVU) must be complied with when installing the heater in bathrooms and
shower rooms. The heater must be positioned so that the pull switch cannot be directly touched from
the bathtub or shower. Device must not be installed above bathtub!
The appliance is not to be used by children or persons with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been given supevision or instruction. Children being
supervised not to play with the appliance.
Automatic switch-o function // Art. no.: 1902.06
The heater (item no.: 1902.06) has a build-in automatic cut o function, i.e. the heater cuts o automatically
after 10 minutes. To restart the heater again you have to pull the cord.
In the event of a power failure or with defective fuses, automatic shutdown will automatically be started
for additional 10 minutes if the switch is in ON position. After use or expiration of the turn-o time, please
make sure the switch is in OFF/0 position.
Repairs
The device may only be repaired by an expert.
- 10 -