GreenWorks Tools 25297 Manuel D'utilisation page 21

EN
DE
FR DE ES IT
FR EN ES IT
Deutsch (Übersetzung der originalen Anleitungen)
TROUBLESHOOTING
Problem
Handle is not in position.
Mower is not starting.
Mower is cutting grass unevenly.
Mower is not mulching properly.
Mower is hard to push.
Mower is not bagging properly.
Mower is vibrating at higher speed.
Motor stops while cutting.
If these solutions do not solve the problem contact your authorised service dealer.
■ Be careful during adjustment of the machine to prevent entrapment of the fingers between moving blades and fixed
parts of the machine.
■ Always allow the machine to cool downbefore storing.
■ When servicing the blades be aware that, even though the power source is switched off, the blades can still be moved.
Separate collection of used products
and packaging allows materials to
be recycled and used again. Re-use
of recycled materials helps prevent
environmental pollution and reduces
the demand for raw materials.
PT NL SV DA NO FI
PT NL SV DA NO FI
English (Original instructions)
Possible cause
Carriage bolts
properly.
Cam handle is not tightened.
Battery is low in charge.
Battery is either inoperable or will not
take a charge.
Lawn is rough or uneven or cutting
height not set properly.
Wet grass clippings are sticking to
the underside of the deck.
High grass, rear of mower housing
and blade are dragging in heavy
grass, or cutting height too low.
Cutting height is set too low.
Blade is unbalanced, excessively or
unevenly worn.
Motor shaft is bent.
Cutting height is set too low.
Battery has no power.
HU CS RU RO PL
HU CS RU RO PL SL
Adjust the height of the handle and
are not seated
make sure the carriage bolts are
seated properly.
Tighten cam handle.
Charge the battery.
Replace the battery.
Move the wheels to a higher position.
All wheels must be placed in the
same cutting height for the mower to
cut evenly.
Wait until the grass dries before
mowing.
Raise the cutting height.
Raise the cutting height.
Replace the blade.
Stop the motor, remove isolator key
and battery, disconnect the power
source, and inspect for damage.
Have it repaired by an authorised
service center before restarting.
Raise the cutting height.
Charge the battery.
At the end of their useful life, discard batteries with due
care for our environment. The battery contains material
which is hazardous to you and the environment. It must
be removed and disposed of separately at a facility that
accepts lithium-ion batteries.
19 19
SL HR ET LT LV SK BG
HR ET LT LV SK BG
Solution