Assemble & Detach Rear Wheels; Assemble & Detach Armbar; Assemble Canopy; Stroller Operation - Joie litetrax E Manuel D'utilisateur

Assemble & Detach Rear Wheels
see images
-
5 6
Assemble & Detach Armbar
see images
-
7 8

Assemble Canopy

see images
9
The completely assembled stroller is shown as
10

Stroller Operation

Adjust Backrest

see images
-
11 12
Recline Backrest
11
Pull tab to recline backrest.
! Hold the backrest with the other hand if a child is already seated in the stroller.
Raise Backrest
Hold both left and right strings and push up the angle adjuster to raise backrest.
! Make sure the recline is set properly for use.

Use Buckle

see images
13 - 14
Release Buckle
Press the center button to release the buckle. 13
Lock Buckle
Match the waist belt buckle with the shoulder buckle
A "click" sound means the buckle is locked completely.
! To avoid serious injury from falling or sliding out, always secure your child with harness.
! Make sure your child is snugly secured. The space between the child and the shoulder harness is about the
thickness of one hand.
! Do not cross the shoulder belts. This will cause pressure on a child's neck.
Use Shoulder & Waist Harnesses
see images
- 18
15
! In order to protect your child from falling out, after your child is placed into the seat, check whether the
shoulder and waist harnesses are at proper height and length.
15 - 1 Shoulder harness anchor A
15 - 2 Shoulder harness anchor B
15 - 3 Slide adjuster
13
12
14 - 1, and click into the center buckle. 14 - 2
14 - 3
For larger child, use shoulder harness anchor A and the highest shoulder slots. For smaller child, use shoulder
harness anchor B and the lowest shoulder slots.
To adjust the position of the shoulder harness, twist the harness strap from the top anchor position.
Then feed the strap through to the front of the seat, Adjust the height as required and feed back through.
! Once the shoulder harness height is set, the strap MUST also be fixed through the highest slot in the backrest.
Use slide adjuster to change the harness length. 18
Press the button 18 - 2, while pulling the waist harness to proper length.

Adjust Calf Support

see images
19
The calf support has 2 positions.
To raise the calf support, push it upwards. A "click" sound means the calf is locked completely.
To lower calf support, press the adjustment buttons on both sides of the calf support
19 - 2
support downwards.

Use Front Swivel Lock

see images
20
Push up the front swivel locks to maintain the moving direction.
Tip
It is recommended to use swivel locks on uneven surfaces.

Use Brake

see images
-
21 22
To lock wheels, step the brake lever downwards. 21
To release wheels, just lift the brake lever upwards.
Tip
Always set the parking brake when stroller is not moving.

Use Canopy

see images
23
The canopy can be opened or folded, pull it toward front or back.

Fold Stroller

see images
-
24 26
! Please fold the canopy before folding the stroller.
1. Press the button and pull the strap to folding webbing upward, the frame will automatically fold backward.
2. The storage latch will automatically hook onto the storage mount, then the stroller is folded and locked
completely. 25
3. The stroller can stand when folded. 26
16
- 1
18 - 3
19 - 1
, and rotate the calf
20
22
23
17
- 2
24
14 14