Configuration - Ingeteam INGECON EMS Manager Manuel D'installation

Ingeteam
Connect as shown in the following figure, installing current transformers on each phase.
See Section "Appendix 2: Current Transformer" for further information on the transformers.
The wattmeter must be installed downstream from the power consumption and production installation.
RS-485 communications are as indicated in the following table.
See Section "2.4. Description of Connection Points" for information on the connection with
INGECON EMS Manager.
Lastly, power the wattmeter as indicated.

Configuration

This section includes the wattmeter configuration parameters required to ensure it operates correctly with the
INGECON EMS Manager.
1. Supply power to the wattmeter from the
electrical grid.
2. Choose position 1 using the selector.
3. Access the Configuration menu by pressing the
joystick for 3 seconds. A passkey will be requested.
By default, this key is 0. Once you have entered the
key press the joystick once to accept.
40 - English
1 3 5 7 8
L1
L2
L3
N
Connection
41
42
43
55
N
L
9 10 11 12 13
Signal
A
B
GND
57
230 VAC
PASS?
AAX2002IKH06_A - Installation manual
Appendix 1: Wattmeter
0
PRG