Ingeteam INGECON EMS Manager Manuel D'installation page 31

Unit Description
Ethernet
The Ethernet connection via the RJ45 connector is used for internet connections and to connect existing inverters
in the installation to the device.
RS-485 communications may be used if there are several units in the same phase of the installation.
A switch is required to deal with all connections (not supplied with the INGECON EMS Manager).
For correct internet connections, the UDP80 port on the router connected to the INGECON EMS
Manager must be open.
USB
No assigned function.
Potential free contacts
The INGECON EMS Manager has two potential free outputs.
Their function will depend on the devices existing in the installation.
• Control of single-phase loads for their connection and disconnection.
• Storage systEMS for decoupling from the grid to become an off-grid network.
• Other functions.
AAX2002IKH06_A - Installation manual
2 1
A2 B2 A1 B1
Description of the potential free contacts in the INGECON EMS Manager
Ingeteam
English - 31