ADURO P2 Mode D'emploi page 44

Table des Matières

Publicité

People with reduced physical, sensory or mental capabilities or lack of experience and knowledge
can use the stove if they have been given supervision or instruction concerning use of the stove in a
safe way and understand the hazards involved.
Make sure children are not left unattended and do not use the stove as a toy.
Persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge
can use the stove if they have been given supervision or instruction concerning use of the stove in a
safe way and understand the hazards involved.
Turn off the stove, disconnect it from the power supply and wait until it has cooled down
completely before performing any maintenance operations. Pull the plug, not the cable.
Never block the combustion air inlets and flue outlets.
Since the stove is fitted with electrical components, do not touch it with wet hands.
Do not use the stove in case of damaged cables or plugs. Should the power supply cable be
damaged, it can be replaced only by the manufacturer or by an authorised service partner.
Do not place any object on the cable and do not bend it.
ATTENTION! DO NOT TOUCH the FIRE DOOR, the GLASS, the HANDLE or the FLUE OUTLET
DURING FUNCTIONING if not wearing adequate protective devices since they become
extremely hot.
Keep inflammable materials, such as furniture, cushions, pillows, blankets, paper, clothing, curtains,
etc., at least 100 cm away from the stove front and 20 cm from the stove sides and back.
Do not immerse the cable, plug or any other stove component in water or other liquids.
Do not use the stove in dusty environments or wherever inflammable vapours are generated (e.g. in
a workshop or garage).
The stove is fitted with components that generate arcs and sparks. Do not install the stove in areas
posing a significant fire or explosion hazard due to a high chemical substance concentration or to a
high humidity level.
Do not use the stove close to bathtubs, showers, basins, sinks or swimming pools.
Do not install the stove underneath an air vent.
Do not install the stove outdoors.
Do not repair, disassemble or modify the stove. The stove is not fitted with components that can be
repaired by users.
ATTENTION! This stove operates exclusively on pellets; DO NOT USE OTHER FUELS: any
other material that may be burnt will result in failure and malfunction of the stove.
Keep the pellets in a fresh, dry place: storing pellets in a place that is damp or excessively
cold may reduce the stove's potential heat output. Be careful when storing and handling
pellet bags to prevent pellet crushing and consequent sawdust production.
The use of different types of pellets may result in a slight, sometimes even undetectable, change in
the stove efficiency. This change can be counterbalanced by increasing or decreasing the stove's
heat output by only one step.
Clean the brazier on a regular basis upon every ignition or pellet refuelling.
Do not switch the stove on and off intermittently to avoid damaging its electrical and electronic
components.
Do not use liquid fuels.
Use only original spare parts provided by Aduro A/S.
Avoid any improper transfers or knocks that may damage the structure or the components.
The metal structure is coated using high temperature paints. When using the stove for the first few
times, unpleasant odours may be given off due to the paint of the metal parts that is drying: this is in
no way dangerous and if it happens, simply ventilate the premises. After the first heating cycles, the
paint will reach its maximum adhesion and all its chemical and physical features.
44

Publicité

Table des Matières
loading

Table des Matières