Prior To Fi Rst Use; For Your Safety - DS Produkte TXG-DS11 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Prior to fi rst use
ATTENTION!
❐ Keep children and animals away from the packaging. Danger of suffocation exists!
❐ Burn hazard! The appliance is very hot during use and afterwards! When setting up the
appliance, make sure you choose an area with adequate space around the appliance (at least
20 cm on the sides and 30 cm above).
1. Unpack the appliance and make sure that the scope of delivery is complete (see chapters
"Appliance overview" and "Accessories") and check for any damages from transport. Should
you identify any transport damage, do not use the appliance(!); instead please promptly con-
sult the customer service.
2. There may be some production residues stuck to the appliance. To avoid health risks, clean
the inside of the housing and the accessories thoroughly before fi rst use (see chapter "Clean-
ing").
3. Place the appliance on a dry, heat-resistant and even surface at a suffi cient distance to fl am-
mable objects. Please ensure that the appliance is not accessible to children.
4. Insert the mains plug in a properly installed 220 – 240 V socket with earthing contacts.
5. The fi rst time you use the appliance, do so without food as residual coating could cause a
small amount of odour or smoke to form. Let the empty appliance heat up for approximately
15 minutes at the highest temperature setting (see chapter "Use"). In the process, ensure that
the room is well ventilated, e.g. with windows that have been opened wide!

For your safety

The appliance is equipped with a safety mechanism, which automatically deactivates the ap-
pliance if it overheats during operation. If the appliance automatically deactivates during op-
eration, set the timer and the temperature control to the OFF position and pull the mains
plug out of the socket. Let the appliance cool off completely and then push the RESET button
(see chapter "Appliance overview") on the bottom of the appliance before reconnecting and
using the appliance again.
The appliance is equipped with an internal timer. After the set time has elapsed, a signal is
emitted and the heat supply will automatically deactivate. The timer must be reset in order
to reactivate the appliance.
The appliance automatically deactivates if the tray with the basket insert is taken out of the
appliance. For your own safety, always turn off the appliance by setting the timer and temper-
ature control to the OFF position before taking the tray out of the appliance.
21

Publicité

Table des Matières
loading

Table des Matières