Parameter Settings - Parker Hiross StarlettePlus-E Manuel D'utilisation

5 Control
QS
Main power switch
UP button: press to increase the value of a selected
parameter
DOWN button: press to reduce the value of a selected
parameter
esc
ESC button :returns to the previous level
SET button : one single press to see the alarms, press
set
for more seconds to enter Menu (Service e Factory)
(lit) Dew point correct
(Flashing) warning dew point high/low
(off) alarm dew point
(lit) Condensate drain ON
(off) Condensate drain OFF
(lit) Multiple alarms
(Flashing) Warning "maintenance"
Degree

5.1 Parameter settings

There are two levels of protection for parameters:
a) User (U): with immediate access, User-changeable;
b) Password protected Factory/Service (F/S): password required
for access; Factory-set parameters.
Condensate drain
There are two operating modes:
a) TIMED (TIm) - with draining at intervals and settable time;
in this confi guration keep pressed
English
work;
b) EXTERN (CON) - if there is an external drain.
For chosing the set proceed as follows::
Press button
Using buttons
fi rm.
Using buttons
esc
Press to confi rm and exit.
In the same way it is possible to change interval and discharge
times of the drain.
Parameter table
Code
dON
dOFF
CHd
ALC
OFF = relay energised only
to force the drain to
set
over 5 seconds to enter on menu U.
and select "CHd" and press
and select "TIm" or "CON" .
Defi nition De- Min
fault
Time ON Drain 5 1
Time OFF Drain 120 20
Confi guration drain TIm TIm
relay alarm/warning ON OFF
ON = relay energised for
alarms/warnings
alarms
Flow Chart
set
>5 sec.
Menu
CHd
User
set
esc
TIm
CON
SPE004-100
Alarms/Warnings
When an alarm is ON, the "alarm/warning code" fl ashing on dis-
play.
set
Multiple alarms appear in sequence. The symbol appears
to con-
In any case you can press
tons and .
Code Description alarm / warning
--- No alarms present
HdP Alarm High Dew point
LdP Alarm Low Dew Point
Max.
DSE Alarm sensor B1 faulti/disconnected
60
H Warning High Dew point
2700
L Warning Low Dew point
CON
esc
Press to exit.
ON
set
<5 sec.
Code 1
Code 2
Alarm Alarm
Warning
Warning
esc
esc
.
set
to see the alarms, using the but-
Flow Chart
Code....
Alarm
Warning
esc
.
3 / 6