WAGNER 905 Power Steamer Guide D'utilisation page 4

Setup:
1. Insert the carrying handle into its slot on the container as
shown. Secure the handle using the magnetic screwdriver
and screw.
2. Attach the steam plate or cleaning accessory to the trigger
mechanism. If using the jet nozzle, assemble the brush onto
the nozzle. If using an extension, attach the extension to the
trigger mechanism, then attach the accessory to the extension.
3. Press trigger button to remove any remaining steam from
the system. Flip up filler cap lid and carefully unscrew filler
cap. Using the funnel and measuring cup, fill the steamer
with clean tap water (distilled water recommended). DO
NOT OVERFILL.
5. Plug in the power cord and turn the switch ON (switch light
will turn on). DO NOT leave steam plate unattended, or
face down on any surfaces. Once the switch is turned ON,
it will take about 4-12 minutes to produce steam. Once the
amber indicator light on the container turns off, you are
ready to begin steaming.
NOTE - The amber indicator light may illuminate during
usage. This is normal. If you notice a drop in steam
pressure, release trigger until the indicator light turns off
English
Do not look directly down
into the fill hole when
filling. Keep your free
hand and others at a safe
distance.
NOTE - The screw can be found in a bag down inside
the carrying handle.
NOTE - Before unscrewing the filler cap and filling
the reservoir, make sure any remaining water has
cooled for at least twenty (20) minutes. Empty any
remaining water to avoid over-filling.
NOTE - Never use more than two extensions when
using the steamer.
Never attach extensions or accessories while
unit is emitting steam.
4. Use the chart below as a guide to determine how much
water you will need based on how long you need to use
the steamer. Replace fill cap and shut filler cap lid when
filled with desired amount.
Amount of
water
16 oz.
32 oz.
48 oz.
6. You can control the flow of steam from the steam plate by
activating the trigger. To have a contiuous flow of steam
from the plate, the trigger can be locked into place:
a) Press and hold trigger.
b) Slide the switch lock forward.
c) Slide the switch lock back to
release.
4
Steam
time
15 min
30 min
45 min