Jeti Mezon PRO 50A BEC Notice D'utilisation page 27

5 Explanation of Status
Start
Commutation - it occurs if the controller is unable to read the
Current
Temperature - it occurs if the temperature is greater than the
Control input - it occurs if the controller detects incorrect
Voltage
Capacity
Memory
www.modellmarkt24.ch www.modellmarkt24.ch
- it occurs if the start sequence takes more than 3s
position of the rotor correctly
- it occurs if the current is greater than the set limit
(Limit->Maximum current)
set limit (Limit->Maximum temperature)
throttle value
- it occurs if the voltage is less than the evaluated
cut-off voltage (Limit->Off voltage set)
- it occurs if capacity is greater than the limit
(Limit->Elapsed capacity)
- it occurs if the memory is inconsistent and the
device is reset to factory settings
27
EN