Cleaning The Condenser - Gamko FK20/2i Mode D'emploi

Installation
1. The cabinet should not be placed in direct sunlight!
2. The cabinet should be installed on a level surface. When the cabinet
is uneven, the door will not close properly.
3. After installation, leave the cabinet standing for at least two hours
before switching on to avoid damaging the compressor.
4. Voltage: For the correct voltage please refer to the indication plate
inside the cabinet.
5. For an optimum temperature, install the cabinet in a position where
adequate air circulation is guaranteed. For: lower energy costs, higher
cooling capacity.
The guarantee will be void if the ventilation vents of the product are
partly or wholly obstructed. An unrestricted circulation of air is essen-
tial to ensure optimal cooling performance and a long working life.
6. Do not cover the plate with air flow grills.
7. The temperature in the cabinet can be adjusted by the thermostat
8. Automatic defrost is standard on the cabinet.
9. The ideal temperature is dependent upon the quality and temperature
of the products to be cooled and is also affected by the ambient tem-
perature.
Cleaning the condenser
The HFK cooler is equipped with a low maintenance condenser that
only requires cleaning in extreme circumstances. Under normal conditi-
ons this low maintenance condenser will extend the life of your cooler
and reduces maintenance costs.
The FK cooler is equipped with a finned condenser. Clean the conden-
ser, once a week, by means of a vacuum cleaner or a brush.
18