Operation; General - Hatco Glo-Ray GRAM Série Manuel D'installation Et D'utilisation

English

General

Use the following information to operate the Glo-Ray
Strip Heaters.
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
BURN HAZARD : Some exterior surfaces on unit will get
hot. Use caution when touching these areas.
Standard and approved manufacturing oils may smoke up
to 30 minutes during initial startup. This is a temporary
condition. Operate unit without food product until smoke
dissipates.
Controls
Strip heaters come with a built-in toggle switch or a remote
mounted control. The following is a list of the available controls
for the strip heaters.
NOTE: Built-in toggle switches are only available for units 18"
(457 mm) to 60" (1524 mm) in length.
I/O (on/off) Toggle Switch—Turns power on and off to the
heating elements and/or the lights (depending on control
configuration).
Electronic Infinite Switch—Turns on the power and controls
the output of the heating elements. The electronic infinite
control is available on a remote control enclosure.
Lights I/O (on/off) Toggle Switch—Turns power on and off
to the lights.
Indicator Light—Illuminates when power is on, shuts off when
power is off.
NOTE: Toggle switches cannot be used on circuits that exceed
15 amps.
Startup
1. Turn on the heating element(s). The indicator light (if
equipped) will illuminate and the heating elements will
energize.
• If unit is equipped with a I/O (on/off) toggle switch, move
the toggle switch to the I (on) position.
• If unit is equipped with an optional infinite control(s), turn
the control to the desired setting.
NOTE: Allow 15–20 minutes to reach operating temperature.
2. On models equipped with display lights, move the Light I/O
(on/off) toggle switch to the I (on) position.
Form No. GRAMM-1220
®
CAUTION
Max Watt
I/O (on/off)
Toggle Switch
I/O (on/off)
Toggle Switch
Shutdown
1. Move the I/O (on/off) toggle switch to the O (off) position or
turn the optional infinite control(s) to the O (off) position.
• The indicator light (if equipped) will shut off and the
heating elements will shut down.
2. On models equipped with display lights, move the Lights
I/O (on/off) toggle switch to the O (off) position.
15

OPERATION

RMB Series
Indicator Light
RMB2 Series
Indicator
Electronic
Light Infinite Switch
Remote Control Enclosures