Talk Button; Selective Paging - RCF BM 3003 Manuel De L'utilisateur

4
The TALK button turns the microphone on (allowing to page).
BM 3003 paging microphones operate in the SMART mode:
- If the TALK button is pressed and quickly released, the microphone will be
turned on / off ('toggle').
- If the TALK button is pressed and held, the microphone will be turned on until
the button is released (even if it has been previously activated as 'toggle').
a. Verify that the line is not engaged (ON / BUSY LED is indicating green).
b. Select the zone(s) buy using the ZONE A, B, C
zone is selected, the TALK
c. Press and release the TALK
previous paragraph 'TALK button operation').
d. The paging microphone can be enabled:
- IMMEDIATELY
4
The TALK red LED and the green zone LEDs
The user can start talking immediately.
2
ZONE LED green
4
TALK LED red
- AFTER THE CHIME
If the chime is enabled in the respective input of the ES 3323 amplifier, it
is necessary to await (just a few seconds, it depends on the chime length)
before talking.
When the chime is playing, both the red TALK LED
ones of the selected zones 2 are flashing.
2
ZONE LED flashing green
4
TALK LED flashing red
After a few seconds and with no other events in progress, LEDs get
steady lit, indicating that now it is possible to talk.
3
buttons (note: if no
5
button cannot be activated).
5
button (or press and hold, see the
2
are steady lit.
4

SELECTIVE PAGING

and the green

TALK BUTTON

9